\\ 3000W BMX E-BIKE [4.0] PART 6 - FINAL \\

In part 6 we finally finish the entire build. We do have a few small things to finish up, but after that I can take it on a speed run, test ride and show it off in all it’s glory!

Sewing Patches

I got these rubber patches from to finally complete this bag. These patches are extremely tough and last a very long time, I had never bought this kind with the rubber backing before however. You’re supposed to iron them on, but I was skeptical on how well I was going to be able to place these and also how well they would hold up over time. I really didn’t want these flapping around after a while due to the adhesive giving way. I thought sewing them on would allow me the best placement while also being able to remove them later if I messed up. It went well, but it did take me 3+ hours to finish this! The rubber is hard to sew, plus the adhesive likes to grab the needle so it wasn’t the easiest job to do but I did finish it, and it looks pretty good!

Final Assembly

With the patches finally on I could continue completing the final assembly.

Installing the custom acrylic side panels!

Throwing on the pedals!

Of course I couldn’t leave those ‘mountain dew’ neon green valve caps on there.

Finishing Touches

I thought I was done, and greanted this build is already graphics heavy, but these extra decals just added the final touches.

Putting on the final decals.

Speed Run

So how fast does it go? 45MPH was the fastest run yet!

Completed Build

Finally completed!

It was a long time coming, but the build is finally completed! I had a lot of fun and learned a ton of things along the way. I can’t wait to make more unique ebikes for you all to see, thanks so much for watching and reading.